CME-55 on 300 Carrier Drill

Optional Equipment

Hydraulic rod holder and
breakout wrench†

The hydraulic rod holder makes your job quicker and safer. It not only pivots from on-hole to off-hole positions, but also hydraulically moves in and out. For efficient operation, the breakout wrench is mounted at the pivot point of the rod holder arm.

Our 140 pound [63.5 kg] automatic hammer gives you extremely consistent and accurate Standard Penetration Test results, meeting all ASTM-D-1586-99 requirements. That's because there are no ropes or cables to impede the free fall of the weight.

The hammer swings from stored position to on-hole position. Since raising and lowering is done hydraulically, set up is quick and almost effortless.

For maximum safety, all moving parts are enclosed, including the impact area between the weight and the anvil. A 340/140 pound [154/63.5 kg] hammer is also available.

Above deck auger and rod racks are provided with the drill platform.

Several tool box, water tank, auger and rod storage configurations are available.

Quick mast disconnect†

This feature allows you to quickly disconnect the mast when working inside buildings, underneath bridges or in other low overhead drilling locations. Since the mast is completely separated from the upright, is doesn't interfere with other drill functions such as the in-out slide base.

With the mast in the horizontal position, you simply clamp it to its storage rack and extend the drills in-out slide base. This pulls the sockets on the upright drill frame away from the large tapered pins on the mast.

Angle drilling system for special applications†

This unique system allows you to drill holes at various angles between horizontal and vertical. It is especially effective for drilling under ponds, storage tanks or other structures. When used with our patented Continuous Sample Tube System, you can even take soil samples while drilling angle holes.

The angle drilling system will also allow you to drill vertically with the rig positioned on an uphill slope. That can eliminate the time consuming job of leveling an area on which to place the rig.

Since the kelly drive is directly connected to the right angle drive box, you can raise and lower the mast with the drivetrain already connected and ready to go.

Additional optional equipment
• Water tank
• High torque rotary drive
  • 9,366 foot pounds [12,698 Nm] max
• High speed rotary drive
  • 787 rpm max
• Auger and rod guides for angle drilling
• Mast (from base of frame to sheaves)
  • 18 foot [5.5 m]
• Cathead, 8 inch [20.3 cm] diameter
• Hydraulic hoist
  • 1,800 pound [816 kg]
    • max line speed 200 ft [61 m] per minute
  • 3,200 pound [1,452 kg]
    • max line speed 100 ft [30.5 m] per minute
  • 5,000 pound [2,268 kg]
    • max line speed 50 ft [15 m] per minute
• Hydraulic wireline hoist
  • 1,800 pound [816 kg]
• Water pumps
  • Moyno Progressive cavity
    • 36 gpm/225 psi [136 lpm/1,551 kPa]
    • 84 gpm/225 psi [318 lpm/1,551 kPa]
  • FMC/Bean
    • 25 gpm/500 psi [ 95 lpm/3,448 kPa]
    • 35 gpm/500 psi [132 lpm/3,448 kPa]
  • Other pumps available